signal: Remove ifdefs for BUS_MCEERR_AR and BUS_MCEERR_AO
With the recent architecture cleanups these si_codes are always
defined so there is no need to test for them.
Signed-off-by: "Eric W. Biederman" <ebiederm@xmission.com>
diff --git a/fs/signalfd.c b/fs/signalfd.c
index d2187a8..ff302bf 100644
--- a/fs/signalfd.c
+++ b/fs/signalfd.c
@@ -117,26 +117,15 @@
#ifdef __ARCH_SI_TRAPNO
err |= __put_user(kinfo->si_trapno, &uinfo->ssi_trapno);
#endif
-#ifdef BUS_MCEERR_AO
/*
* Other callers might not initialize the si_lsb field,
* so check explicitly for the right codes here.
*/
if (kinfo->si_signo == SIGBUS &&
- kinfo->si_code == BUS_MCEERR_AO)
+ ((kinfo->si_code == BUS_MCEERR_AR) ||
+ (kinfo->si_code == BUS_MCEERR_AO)))
err |= __put_user((short) kinfo->si_addr_lsb,
&uinfo->ssi_addr_lsb);
-#endif
-#ifdef BUS_MCEERR_AR
- /*
- * Other callers might not initialize the si_lsb field,
- * so check explicitly for the right codes here.
- */
- if (kinfo->si_signo == SIGBUS &&
- kinfo->si_code == BUS_MCEERR_AR)
- err |= __put_user((short) kinfo->si_addr_lsb,
- &uinfo->ssi_addr_lsb);
-#endif
break;
case SIL_CHLD:
err |= __put_user(kinfo->si_pid, &uinfo->ssi_pid);