ixgb: convert to new VLAN model
Based on a patch from Jesse Gross <jesse@nicira.com>
This switches the ixgb driver to use the new VLAN interfaces.
In doing this, it completes the work begun in
ae54496f9e8d40c89e5668205c181dccfa9ecda1 allowing the use of
hardware VLAN insertion without having a VLAN group configured.
CC: Jesse Gross <jesse@nicira.com>
Signed-off-by: Emil Tantilov <emil.s.tantilov@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ixgb/ixgb_ethtool.c b/drivers/net/ixgb/ixgb_ethtool.c
index 43994c1..cc53aa1 100644
--- a/drivers/net/ixgb/ixgb_ethtool.c
+++ b/drivers/net/ixgb/ixgb_ethtool.c
@@ -706,6 +706,43 @@
}
}
+static int ixgb_set_flags(struct net_device *netdev, u32 data)
+{
+ struct ixgb_adapter *adapter = netdev_priv(netdev);
+ bool need_reset;
+ int rc;
+
+ /*
+ * Tx VLAN insertion does not work per HW design when Rx stripping is
+ * disabled. Disable txvlan when rxvlan is turned off, and enable
+ * rxvlan when txvlan is turned on.
+ */
+ if (!(data & ETH_FLAG_RXVLAN) &&
+ (netdev->features & NETIF_F_HW_VLAN_TX))
+ data &= ~ETH_FLAG_TXVLAN;
+ else if (data & ETH_FLAG_TXVLAN)
+ data |= ETH_FLAG_RXVLAN;
+
+ need_reset = (data & ETH_FLAG_RXVLAN) !=
+ (netdev->features & NETIF_F_HW_VLAN_RX);
+
+ rc = ethtool_op_set_flags(netdev, data, ETH_FLAG_RXVLAN |
+ ETH_FLAG_TXVLAN);
+ if (rc)
+ return rc;
+
+ if (need_reset) {
+ if (netif_running(netdev)) {
+ ixgb_down(adapter, true);
+ ixgb_up(adapter);
+ ixgb_set_speed_duplex(netdev);
+ } else
+ ixgb_reset(adapter);
+ }
+
+ return 0;
+}
+
static const struct ethtool_ops ixgb_ethtool_ops = {
.get_settings = ixgb_get_settings,
.set_settings = ixgb_set_settings,
@@ -732,6 +769,8 @@
.phys_id = ixgb_phys_id,
.get_sset_count = ixgb_get_sset_count,
.get_ethtool_stats = ixgb_get_ethtool_stats,
+ .get_flags = ethtool_op_get_flags,
+ .set_flags = ixgb_set_flags,
};
void ixgb_set_ethtool_ops(struct net_device *netdev)