i2c: Allow i2c_add_numbered_adapter() to assign a bus id
Currently, if an i2c bus driver supports both static and dynamic bus
ids, it needs to choose between calling i2c_add_numbered_adapter() and
i2c_add_adapter(). This patch makes i2c_add_numbered_adapter()
redirect to i2c_add_adapter() if the requested bus id is -1.
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Jean Delvare <khali@linux-fr.org>
diff --git a/drivers/i2c/i2c-core.c b/drivers/i2c/i2c-core.c
index 9a58994..131079a 100644
--- a/drivers/i2c/i2c-core.c
+++ b/drivers/i2c/i2c-core.c
@@ -925,6 +925,9 @@
* or otherwise built in to the system's mainboard, and where i2c_board_info
* is used to properly configure I2C devices.
*
+ * If the requested bus number is set to -1, then this function will behave
+ * identically to i2c_add_adapter, and will dynamically assign a bus number.
+ *
* If no devices have pre-been declared for this bus, then be sure to
* register the adapter before any dynamically allocated ones. Otherwise
* the required bus ID may not be available.
@@ -940,6 +943,8 @@
int id;
int status;
+ if (adap->nr == -1) /* -1 means dynamically assign bus id */
+ return i2c_add_adapter(adap);
if (adap->nr & ~MAX_ID_MASK)
return -EINVAL;