mmc: Fixes for Dual Data Rate (DDR) support
The DDR support patch needs the following fixes:
- The block driver does not need to know about DDR, any more
than it needs to know about bus width.
- Not only the card must be switched to DDR mode. The host
controller must also be configured, which is done through
the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
is successful.
- Setting block length is not supported in DDR mode. Make that
a core function and change the other place it is used (mmc_test)
also.
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/include/linux/mmc/core.h b/include/linux/mmc/core.h
index d0fbcac..64e013f 100644
--- a/include/linux/mmc/core.h
+++ b/include/linux/mmc/core.h
@@ -109,7 +109,6 @@
#define MMC_DATA_WRITE (1 << 8)
#define MMC_DATA_READ (1 << 9)
#define MMC_DATA_STREAM (1 << 10)
-#define MMC_DDR_MODE (1 << 11)
unsigned int bytes_xfered;
@@ -154,6 +153,8 @@
extern int mmc_erase_group_aligned(struct mmc_card *card, unsigned int from,
unsigned int nr);
+extern int mmc_set_blocklen(struct mmc_card *card, unsigned int blocklen);
+
extern void mmc_set_data_timeout(struct mmc_data *, const struct mmc_card *);
extern unsigned int mmc_align_data_size(struct mmc_card *, unsigned int);