#define TWI1_REGBASE 0xffc02200
#define TWI1_CLKDIV 0xffc02200 /* Clock Divider Register */
#define TWI1_CONTROL 0xffc02204 /* TWI Control Register */
-#define TWI1_SLAVE_CTRL 0xffc02208 /* TWI Slave Mode Control Register */
+#define TWI1_SLAVE_CTL 0xffc02208 /* TWI Slave Mode Control Register */
#define TWI1_SLAVE_STAT 0xffc0220c /* TWI Slave Mode Status Register */
#define TWI1_SLAVE_ADDR 0xffc02210 /* TWI Slave Mode Address Register */
-#define TWI1_MASTER_CTRL 0xffc02214 /* TWI Master Mode Control Register */
+#define TWI1_MASTER_CTL 0xffc02214 /* TWI Master Mode Control Register */
#define TWI1_MASTER_STAT 0xffc02218 /* TWI Master Mode Status Register */
#define TWI1_MASTER_ADDR 0xffc0221c /* TWI Master Mode Address Register */
#define TWI1_INT_STAT 0xffc02220 /* TWI Interrupt Status Register */
#define TWI1_INT_MASK 0xffc02224 /* TWI Interrupt Mask Register */
-#define TWI1_FIFO_CTRL 0xffc02228 /* TWI FIFO Control Register */
+#define TWI1_FIFO_CTL 0xffc02228 /* TWI FIFO Control Register */
#define TWI1_FIFO_STAT 0xffc0222c /* TWI FIFO Status Register */
#define TWI1_XMT_DATA8 0xffc02280 /* TWI FIFO Transmit Data Single Byte Register */
#define TWI1_XMT_DATA16 0xffc02284 /* TWI FIFO Transmit Data Double Byte Register */
#define KPAD_SOFTEVAL_E 0x2 /* Software Programmable Force Evaluate */
-/* Bit masks for SDH_COMMAND */
-
-#define CMD_IDX 0x3f /* Command Index */
-#define CMD_RSP 0x40 /* Response */
-#define CMD_L_RSP 0x80 /* Long Response */
-#define CMD_INT_E 0x100 /* Command Interrupt */
-#define CMD_PEND_E 0x200 /* Command Pending */
-#define CMD_E 0x400 /* Command Enable */
-
-/* Bit masks for SDH_PWR_CTL */
-
-#define PWR_ON 0x3 /* Power On */
-#if 0
-#define TBD 0x3c /* TBD */
-#endif
-#define SD_CMD_OD 0x40 /* Open Drain Output */
-#define ROD_CTL 0x80 /* Rod Control */
-
-/* Bit masks for SDH_CLK_CTL */
-
-#define CLKDIV 0xff /* MC_CLK Divisor */
-#define CLK_E 0x100 /* MC_CLK Bus Clock Enable */
-#define PWR_SV_E 0x200 /* Power Save Enable */
-#define CLKDIV_BYPASS 0x400 /* Bypass Divisor */
-#define WIDE_BUS 0x800 /* Wide Bus Mode Enable */
-
-/* Bit masks for SDH_RESP_CMD */
-
-#define RESP_CMD 0x3f /* Response Command */
-
-/* Bit masks for SDH_DATA_CTL */
-
-#define DTX_E 0x1 /* Data Transfer Enable */
-#define DTX_DIR 0x2 /* Data Transfer Direction */
-#define DTX_MODE 0x4 /* Data Transfer Mode */
-#define DTX_DMA_E 0x8 /* Data Transfer DMA Enable */
-#define DTX_BLK_LGTH 0xf0 /* Data Transfer Block Length */
-
-/* Bit masks for SDH_STATUS */
-
-#define CMD_CRC_FAIL 0x1 /* CMD CRC Fail */
-#define DAT_CRC_FAIL 0x2 /* Data CRC Fail */
-#define CMD_TIME_OUT 0x4 /* CMD Time Out */
-#define DAT_TIME_OUT 0x8 /* Data Time Out */
-#define TX_UNDERRUN 0x10 /* Transmit Underrun */
-#define RX_OVERRUN 0x20 /* Receive Overrun */
-#define CMD_RESP_END 0x40 /* CMD Response End */
-#define CMD_SENT 0x80 /* CMD Sent */
-#define DAT_END 0x100 /* Data End */
-#define START_BIT_ERR 0x200 /* Start Bit Error */
-#define DAT_BLK_END 0x400 /* Data Block End */
-#define CMD_ACT 0x800 /* CMD Active */
-#define TX_ACT 0x1000 /* Transmit Active */
-#define RX_ACT 0x2000 /* Receive Active */
-#define TX_FIFO_STAT 0x4000 /* Transmit FIFO Status */
-#define RX_FIFO_STAT 0x8000 /* Receive FIFO Status */
-#define TX_FIFO_FULL 0x10000 /* Transmit FIFO Full */
-#define RX_FIFO_FULL 0x20000 /* Receive FIFO Full */
-#define TX_FIFO_ZERO 0x40000 /* Transmit FIFO Empty */
-#define RX_DAT_ZERO 0x80000 /* Receive FIFO Empty */
-#define TX_DAT_RDY 0x100000 /* Transmit Data Available */
-#define RX_FIFO_RDY 0x200000 /* Receive Data Available */
-
-/* Bit masks for SDH_STATUS_CLR */
-
-#define CMD_CRC_FAIL_STAT 0x1 /* CMD CRC Fail Status */
-#define DAT_CRC_FAIL_STAT 0x2 /* Data CRC Fail Status */
-#define CMD_TIMEOUT_STAT 0x4 /* CMD Time Out Status */
-#define DAT_TIMEOUT_STAT 0x8 /* Data Time Out status */
-#define TX_UNDERRUN_STAT 0x10 /* Transmit Underrun Status */
-#define RX_OVERRUN_STAT 0x20 /* Receive Overrun Status */
-#define CMD_RESP_END_STAT 0x40 /* CMD Response End Status */
-#define CMD_SENT_STAT 0x80 /* CMD Sent Status */
-#define DAT_END_STAT 0x100 /* Data End Status */
-#define START_BIT_ERR_STAT 0x200 /* Start Bit Error Status */
-#define DAT_BLK_END_STAT 0x400 /* Data Block End Status */
-
-/* Bit masks for SDH_MASK0 */
-
-#define CMD_CRC_FAIL_MASK 0x1 /* CMD CRC Fail Mask */
-#define DAT_CRC_FAIL_MASK 0x2 /* Data CRC Fail Mask */
-#define CMD_TIMEOUT_MASK 0x4 /* CMD Time Out Mask */
-#define DAT_TIMEOUT_MASK 0x8 /* Data Time Out Mask */
-#define TX_UNDERRUN_MASK 0x10 /* Transmit Underrun Mask */
-#define RX_OVERRUN_MASK 0x20 /* Receive Overrun Mask */
-#define CMD_RESP_END_MASK 0x40 /* CMD Response End Mask */
-#define CMD_SENT_MASK 0x80 /* CMD Sent Mask */
-#define DAT_END_MASK 0x100 /* Data End Mask */
-#define START_BIT_ERR_MASK 0x200 /* Start Bit Error Mask */
-#define DAT_BLK_END_MASK 0x400 /* Data Block End Mask */
-#define CMD_ACT_MASK 0x800 /* CMD Active Mask */
-#define TX_ACT_MASK 0x1000 /* Transmit Active Mask */
-#define RX_ACT_MASK 0x2000 /* Receive Active Mask */
-#define TX_FIFO_STAT_MASK 0x4000 /* Transmit FIFO Status Mask */
-#define RX_FIFO_STAT_MASK 0x8000 /* Receive FIFO Status Mask */
-#define TX_FIFO_FULL_MASK 0x10000 /* Transmit FIFO Full Mask */
-#define RX_FIFO_FULL_MASK 0x20000 /* Receive FIFO Full Mask */
-#define TX_FIFO_ZERO_MASK 0x40000 /* Transmit FIFO Empty Mask */
-#define RX_DAT_ZERO_MASK 0x80000 /* Receive FIFO Empty Mask */
-#define TX_DAT_RDY_MASK 0x100000 /* Transmit Data Available Mask */
-#define RX_FIFO_RDY_MASK 0x200000 /* Receive Data Available Mask */
-
-/* Bit masks for SDH_FIFO_CNT */
-
-#define FIFO_COUNT 0x7fff /* FIFO Count */
-
-/* Bit masks for SDH_E_STATUS */
-
-#define SDIO_INT_DET 0x2 /* SDIO Int Detected */
-#define SD_CARD_DET 0x10 /* SD Card Detect */
-
-/* Bit masks for SDH_E_MASK */
-
-#define SDIO_MSK 0x2 /* Mask SDIO Int Detected */
-#define SCD_MSK 0x40 /* Mask Card Detect */
-
-/* Bit masks for SDH_CFG */
-
-#define CLKS_EN 0x1 /* Clocks Enable */
-#define SD4E 0x4 /* SDIO 4-Bit Enable */
-#define MWE 0x8 /* Moving Window Enable */
-#define SD_RST 0x10 /* SDMMC Reset */
-#define PUP_SDDAT 0x20 /* Pull-up SD_DAT */
-#define PUP_SDDAT3 0x40 /* Pull-up SD_DAT3 */
-#define PD_SDDAT3 0x80 /* Pull-down SD_DAT3 */
-
-/* Bit masks for SDH_RD_WAIT_EN */
-
-#define RWR 0x1 /* Read Wait Request */
-
/* Bit masks for ATAPI_CONTROL */
#define PIO_START 0x1 /* Start PIO/Reg Op */
Code Review / linux-2.6.git / blobdiff