# sound/Config.in # menuconfig SOUND tristate "Sound card support" depends on HAS_IOMEM help If you have a sound card in your computer, i.e. if it can say more than an occasional beep, say Y. Be sure to have all the information about your sound card and its configuration down (I/O port, interrupt and DMA channel), because you will be asked for it. You want to read the Sound-HOWTO, available from . General information about the modular sound system is contained in the files . The file contains some slightly outdated but still useful information as well. Newer sound driver documentation is found in . If you have a PnP sound card and you want to configure it at boot time using the ISA PnP tools (read ), then you need to compile the sound card support as a module and load that module after the PnP configuration is finished. To do this, choose M here and read ; the module will be called soundcore. if SOUND config SOUND_OSS_CORE bool default n source "sound/oss/dmasound/Kconfig" if !M68K menuconfig SND tristate "Advanced Linux Sound Architecture" help Say 'Y' or 'M' to enable ALSA (Advanced Linux Sound Architecture), the new base sound system. For more information, see if SND source "sound/core/Kconfig" source "sound/drivers/Kconfig" source "sound/isa/Kconfig" source "sound/pci/Kconfig" source "sound/ppc/Kconfig" source "sound/aoa/Kconfig" source "sound/arm/Kconfig" source "sound/atmel/Kconfig" source "sound/spi/Kconfig" source "sound/mips/Kconfig" source "sound/sh/Kconfig" # the following will depend on the order of config. # here assuming USB is defined before ALSA source "sound/usb/Kconfig" # the following will depend on the order of config. # here assuming PCMCIA is defined before ALSA source "sound/pcmcia/Kconfig" source "sound/sparc/Kconfig" source "sound/parisc/Kconfig" source "sound/soc/Kconfig" endif # SND menuconfig SOUND_PRIME tristate "Open Sound System (DEPRECATED)" select SOUND_OSS_CORE help Say 'Y' or 'M' to enable Open Sound System drivers. if SOUND_PRIME source "sound/oss/Kconfig" endif # SOUND_PRIME endif # !M68K endif # SOUND # AC97_BUS is used from both sound and ucb1400 config AC97_BUS tristate help This is used to avoid config and link hard dependencies between the sound subsystem and other function drivers completely unrelated to sound although they're sharing the AC97 bus. Concerned drivers should "select" this.