#ifndef DW_SPI_HEADER_H #define DW_SPI_HEADER_H #include /* Bit fields in CTRLR0 */ #define SPI_DFS_OFFSET 0 #define SPI_FRF_OFFSET 4 #define SPI_FRF_SPI 0x0 #define SPI_FRF_SSP 0x1 #define SPI_FRF_MICROWIRE 0x2 #define SPI_FRF_RESV 0x3 #define SPI_MODE_OFFSET 6 #define SPI_SCPH_OFFSET 6 #define SPI_SCOL_OFFSET 7 #define SPI_TMOD_OFFSET 8 #define SPI_TMOD_TR 0x0 /* xmit & recv */ #define SPI_TMOD_TO 0x1 /* xmit only */ #define SPI_TMOD_RO 0x2 /* recv only */ #define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */ #define SPI_SLVOE_OFFSET 10 #define SPI_SRL_OFFSET 11 #define SPI_CFS_OFFSET 12 /* Bit fields in SR, 7 bits */ #define SR_MASK 0x7f /* cover 7 bits */ #define SR_BUSY (1 << 0) #define SR_TF_NOT_FULL (1 << 1) #define SR_TF_EMPT (1 << 2) #define SR_RF_NOT_EMPT (1 << 3) #define SR_RF_FULL (1 << 4) #define SR_TX_ERR (1 << 5) #define SR_DCOL (1 << 6) /* Bit fields in ISR, IMR, RISR, 7 bits */ #define SPI_INT_TXEI (1 << 0) #define SPI_INT_TXOI (1 << 1) #define SPI_INT_RXUI (1 << 2) #define SPI_INT_RXOI (1 << 3) #define SPI_INT_RXFI (1 << 4) #define SPI_INT_MSTI (1 << 5) /* TX RX interrupt level threshhold, max can be 256 */ #define SPI_INT_THRESHOLD 32 enum dw_ssi_type { SSI_MOTO_SPI = 0, SSI_TI_SSP, SSI_NS_MICROWIRE, }; struct dw_spi_reg { u32 ctrl0; u32 ctrl1; u32 ssienr; u32 mwcr; u32 ser; u32 baudr; u32 txfltr; u32 rxfltr; u32 txflr; u32 rxflr; u32 sr; u32 imr; u32 isr; u32 risr; u32 txoicr; u32 rxoicr; u32 rxuicr; u32 msticr; u32 icr; u32 dmacr; u32 dmatdlr; u32 dmardlr; u32 idr; u32 version; u32 dr; /* Currently oper as 32 bits, though only low 16 bits matters */ } __packed; struct dw_spi { struct spi_master *master; struct spi_device *cur_dev; struct device *parent_dev; enum dw_ssi_type type; void __iomem *regs; unsigned long paddr; u32 iolen; int irq; u32 max_freq; /* max bus freq supported */ u16 bus_num; u16 num_cs; /* supported slave numbers */ /* Driver message queue */ struct workqueue_struct *workqueue; struct work_struct pump_messages; spinlock_t lock; struct list_head queue; int busy; int run; /* Message Transfer pump */ struct tasklet_struct pump_transfers; /* Current message transfer state info */ struct spi_message *cur_msg; struct spi_transfer *cur_transfer; struct chip_data *cur_chip; struct chip_data *prev_chip; size_t len; void *tx; void *tx_end; void *rx; void *rx_end; int dma_mapped; dma_addr_t rx_dma; dma_addr_t tx_dma; size_t rx_map_len; size_t tx_map_len; u8 n_bytes; /* current is a 1/2 bytes op */ u8 max_bits_per_word; /* maxim is 16b */ u32 dma_width; int cs_change; int (*write)(struct dw_spi *dws); int (*read)(struct dw_spi *dws); irqreturn_t (*transfer_handler)(struct dw_spi *dws); void (*cs_control)(u32 command); /* Dma info */ int dma_inited; struct dma_chan *txchan; struct dma_chan *rxchan; int txdma_done; int rxdma_done; u64 tx_param; u64 rx_param; struct device *dma_dev; dma_addr_t dma_addr; /* Bus interface info */ void *priv; #ifdef CONFIG_DEBUG_FS struct dentry *debugfs; #endif }; #define dw_readl(dw, name) \ __raw_readl(&(((struct dw_spi_reg *)dw->regs)->name)) #define dw_writel(dw, name, val) \ __raw_writel((val), &(((struct dw_spi_reg *)dw->regs)->name)) #define dw_readw(dw, name) \ __raw_readw(&(((struct dw_spi_reg *)dw->regs)->name)) #define dw_writew(dw, name, val) \ __raw_writew((val), &(((struct dw_spi_reg *)dw->regs)->name)) static inline void spi_enable_chip(struct dw_spi *dws, int enable) { dw_writel(dws, ssienr, (enable ? 1 : 0)); } static inline void spi_set_clk(struct dw_spi *dws, u16 div) { dw_writel(dws, baudr, div); } static inline void spi_chip_sel(struct dw_spi *dws, u16 cs) { if (cs > dws->num_cs) return; dw_writel(dws, ser, 1 << cs); } /* Disable IRQ bits */ static inline void spi_mask_intr(struct dw_spi *dws, u32 mask) { u32 new_mask; new_mask = dw_readl(dws, imr) & ~mask; dw_writel(dws, imr, new_mask); } /* Enable IRQ bits */ static inline void spi_umask_intr(struct dw_spi *dws, u32 mask) { u32 new_mask; new_mask = dw_readl(dws, imr) | mask; dw_writel(dws, imr, new_mask); } /* * Each SPI slave device to work with dw_api controller should * has such a structure claiming its working mode (PIO/DMA etc), * which can be save in the "controller_data" member of the * struct spi_device */ struct dw_spi_chip { u8 poll_mode; /* 0 for contoller polling mode */ u8 type; /* SPI/SSP/Micrwire */ u8 enable_dma; void (*cs_control)(u32 command); }; extern int dw_spi_add_host(struct dw_spi *dws); extern void dw_spi_remove_host(struct dw_spi *dws); extern int dw_spi_suspend_host(struct dw_spi *dws); extern int dw_spi_resume_host(struct dw_spi *dws); #endif /* DW_SPI_HEADER_H */