ARM: move the FIXED_REG macro definition to pmu board files.

This will avoid the duplication of the macro definition across
the power file.

Change-Id: I26573f4f0be77274a7385528ec69256b9252ff22
Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
Reviewed-on: http://git-master/r/272607

diff --git a/arch/arm/mach-tegra/board-pmu-defines.h b/arch/arm/mach-tegra/board-pmu-defines.h
index a4367a7abd463dc835af6c4014df2043d29ece41..aa0bc504d3dff28d67621fae7dbf05e94b8634af 100644 (file)
--- a/arch/arm/mach-tegra/board-pmu-defines.h
+++ b/arch/arm/mach-tegra/board-pmu-defines.h
@@ -114,4 +114,53 @@ static struct as3722_regulator_platform_data as3722_##_name##_reg_pdata =  \
        .ext_control = _ext_cntrl                                       \
 }                                                                      \
 
+
+/* Macro for defining fixed regulator sub device data */
+#define fixed_sync_supply(_name) "fixed_reg_en_"#_name
+
+#define FIXED_REG_DRV(_id, _drv, _var, _name, _in_supply,              \
+       _always_on, _boot_on, _gpio_nr, _open_drain,                    \
+       _active_high, _boot_state, _millivolts, _sdelay)                \
+static struct regulator_init_data ri_data_##_var =                     \
+{                                                                      \
+       .supply_regulator = _in_supply,                                 \
+       .num_consumer_supplies =                                        \
+                       ARRAY_SIZE(fixed_reg_en_##_name##_supply),      \
+       .consumer_supplies = fixed_reg_en_##_name##_supply,             \
+       .constraints = {                                                \
+               .valid_modes_mask = (REGULATOR_MODE_NORMAL |            \
+                                       REGULATOR_MODE_STANDBY),        \
+               .valid_ops_mask = (REGULATOR_CHANGE_MODE |              \
+                                       REGULATOR_CHANGE_STATUS |       \
+                                       REGULATOR_CHANGE_VOLTAGE),      \
+               .always_on = _always_on,                                \
+               .boot_on = _boot_on,                                    \
+       },                                                              \
+};                                                                     \
+static struct fixed_voltage_config fixed_reg_en_##_var##_pdata =       \
+{                                                                      \
+       .supply_name = fixed_sync_supply(_name),                        \
+       .microvolts = _millivolts * 1000,                               \
+       .gpio = _gpio_nr,                                               \
+       .gpio_is_open_drain = _open_drain,                              \
+       .enable_high = _active_high,                                    \
+       .enabled_at_boot = _boot_state,                                 \
+       .init_data = &ri_data_##_var,                                   \
+       .startup_delay = _sdelay                                        \
+};                                                                     \
+static struct platform_device fixed_reg_en_##_var##_dev = {            \
+       .name = #_drv,                                                  \
+       .id = _id,                                                      \
+       .dev = {                                                        \
+               .platform_data = &fixed_reg_en_##_var##_pdata,          \
+       },                                                              \
+}
+
+#define FIXED_SYNC_REG(_id, _var, _name, _in_supply,                   \
+       _always_on, _boot_on, _gpio_nr, _open_drain,                    \
+       _active_high, _boot_state, _millivolts, _sdelay)                \
+       FIXED_REG_DRV(_id, reg-fixed-sync-voltage, _var, _name,         \
+       _in_supply, _always_on, _boot_on, _gpio_nr, _open_drain,        \
+       _active_high, _boot_state, _millivolts, _sdelay)
+
 #endif