target: Fix >= v3.9+ regression in PR APTPL + ALUA metadata write-out
[linux-3.10.git] / drivers / Makefile
index f9b82f2..130abc1 100644 (file)
@@ -5,23 +5,31 @@
 # Rewritten to use lists instead of if-statements.
 #
 
+obj-y                          += irqchip/
+obj-y                          += bus/
+
 # GPIO must come after pinctrl as gpios may need to mux pins etc
 obj-y                          += pinctrl/
 obj-y                          += gpio/
+obj-y                          += pwm/
 obj-$(CONFIG_PCI)              += pci/
 obj-$(CONFIG_PARISC)           += parisc/
 obj-$(CONFIG_RAPIDIO)          += rapidio/
 obj-y                          += video/
 obj-y                          += idle/
+
+# IPMI must come before ACPI in order to provide IPMI opregion support
+obj-$(CONFIG_IPMI_HANDLER)     += char/ipmi/
+
 obj-$(CONFIG_ACPI)             += acpi/
 obj-$(CONFIG_SFI)              += sfi/
 # PnP must come after ACPI since it will eventually need to check if acpi
 # was used and do nothing if so
 obj-$(CONFIG_PNP)              += pnp/
-obj-$(CONFIG_ARM_AMBA)         += amba/
+obj-y                          += amba/
 # Many drivers will want to use DMA so this has to be made available
 # really early.
-obj-$(CONFIG_DMA_ENGINE)       += dma/
+obj-$(CONFIG_DMADEVICES)       += dma/
 
 obj-$(CONFIG_VIRTIO)           += virtio/
 obj-$(CONFIG_XEN)              += xen/
@@ -29,6 +37,9 @@ obj-$(CONFIG_XEN)             += xen/
 # regulators early, since some subsystems rely on them to initialize
 obj-$(CONFIG_REGULATOR)                += regulator/
 
+# reset controllers early, since gpu drivers might rely on them to initialize
+obj-$(CONFIG_RESET_CONTROLLER) += reset/
+
 # tty/ comes before char/ so that the VT console is the boot-time
 # default.
 obj-y                          += tty/
@@ -59,6 +70,7 @@ obj-$(CONFIG_ATM)             += atm/
 obj-$(CONFIG_FUSION)           += message/
 obj-y                          += firewire/
 obj-$(CONFIG_UIO)              += uio/
+obj-$(CONFIG_VFIO)             += vfio/
 obj-y                          += cdrom/
 obj-y                          += auxdisplay/
 obj-$(CONFIG_PCCARD)           += pcmcia/
@@ -70,7 +82,7 @@ obj-$(CONFIG_ATA_OVER_ETH)    += block/aoe/
 obj-$(CONFIG_PARIDE)           += block/paride/
 obj-$(CONFIG_TC)               += tc/
 obj-$(CONFIG_UWB)              += uwb/
-obj-$(CONFIG_USB_OTG_UTILS)    += usb/
+obj-$(CONFIG_USB_PHY)          += usb/
 obj-$(CONFIG_USB)              += usb/
 obj-$(CONFIG_PCI)              += usb/
 obj-$(CONFIG_USB_GADGET)       += usb/
@@ -105,6 +117,7 @@ obj-y                               += firmware/
 obj-$(CONFIG_CRYPTO)           += crypto/
 obj-$(CONFIG_SUPERH)           += sh/
 obj-$(CONFIG_ARCH_SHMOBILE)    += sh/
+obj-$(CONFIG_SSBI)             += ssbi/
 ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
 obj-y                          += clocksource/
 endif
@@ -114,14 +127,14 @@ obj-$(CONFIG_PPC_PS3)             += ps3/
 obj-$(CONFIG_OF)               += of/
 obj-$(CONFIG_SSB)              += ssb/
 obj-$(CONFIG_BCMA)             += bcma/
-obj-$(CONFIG_VHOST_NET)                += vhost/
+obj-$(CONFIG_VHOST_RING)       += vhost/
 obj-$(CONFIG_VLYNQ)            += vlynq/
 obj-$(CONFIG_STAGING)          += staging/
 obj-y                          += platform/
-obj-y                          += ieee802154/
 #common clk code
 obj-y                          += clk/
 
+obj-$(CONFIG_MAILBOX)          += mailbox/
 obj-$(CONFIG_HWSPINLOCK)       += hwspinlock/
 obj-$(CONFIG_NFC)              += nfc/
 obj-$(CONFIG_IOMMU_SUPPORT)    += iommu/
@@ -133,3 +146,9 @@ obj-$(CONFIG_VIRT_DRIVERS)  += virt/
 obj-$(CONFIG_HYPERV)           += hv/
 
 obj-$(CONFIG_PM_DEVFREQ)       += devfreq/
+obj-$(CONFIG_EXTCON)           += extcon/
+obj-$(CONFIG_MEMORY)           += memory/
+obj-$(CONFIG_IIO)              += iio/
+obj-$(CONFIG_VME_BUS)          += vme/
+obj-$(CONFIG_IPACK_BUS)                += ipack/
+obj-$(CONFIG_NTB)              += ntb/