[S390] Use copy_to_absolute_zero() instead of "stura/sturg"
Michael Holzheu [Sun, 11 Mar 2012 15:59:28 +0000 (11:59 -0400)]
Use the new copy_to_absolute_zero() function instead of manual "stura"
and "sturg" to make the code shorter and more readable.

Signed-off-by: Michael Holzheu <holzheu@linux.vnet.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>

arch/s390/kernel/ipl.c

index e5a72a2..9e2f6f7 100644 (file)
@@ -1498,30 +1498,12 @@ static struct shutdown_action __refdata dump_action = {
 
 static void dump_reipl_run(struct shutdown_trigger *trigger)
 {
-       preempt_disable();
-       /*
-        * Bypass dynamic address translation (DAT) when storing IPL parameter
-        * information block address and checksum into the prefix area
-        * (corresponding to absolute addresses 0-8191).
-        * When enhanced DAT applies and the STE format control in one,
-        * the absolute address is formed without prefixing. In this case a
-        * normal store (stg/st) into the prefix area would no more match to
-        * absolute addresses 0-8191.
-        */
-#ifdef CONFIG_64BIT
-       asm volatile("sturg %0,%1"
-               :: "a" ((unsigned long) reipl_block_actual),
-               "a" (&lowcore_ptr[smp_processor_id()]->ipib));
-#else
-       asm volatile("stura %0,%1"
-               :: "a" ((unsigned long) reipl_block_actual),
-               "a" (&lowcore_ptr[smp_processor_id()]->ipib));
-#endif
-       asm volatile("stura %0,%1"
-               :: "a" (csum_partial(reipl_block_actual,
-                                    reipl_block_actual->hdr.len, 0)),
-               "a" (&lowcore_ptr[smp_processor_id()]->ipib_checksum));
-       preempt_enable();
+       u32 csum;
+
+       csum = csum_partial(reipl_block_actual, reipl_block_actual->hdr.len, 0);
+       copy_to_absolute_zero(&S390_lowcore.ipib_checksum, &csum, sizeof(csum));
+       copy_to_absolute_zero(&S390_lowcore.ipib, &reipl_block_actual,
+                             sizeof(reipl_block_actual));
        dump_run(trigger);
 }