netdev: seeq8005 convert to net_device_ops
Stephen Hemminger [Thu, 26 Mar 2009 15:11:28 +0000 (15:11 +0000)]
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/seeq8005.c

index 12a8fff..ebbbe09 100644 (file)
@@ -143,6 +143,17 @@ out:
        return ERR_PTR(err);
 }
 
+static const struct net_device_ops seeq8005_netdev_ops = {
+       .ndo_open               = seeq8005_open,
+       .ndo_stop               = seeq8005_close,
+       .ndo_start_xmit         = seeq8005_send_packet,
+       .ndo_tx_timeout         = seeq8005_timeout,
+       .ndo_set_multicast_list = set_multicast_list,
+       .ndo_change_mtu         = eth_change_mtu,
+       .ndo_set_mac_address    = eth_mac_addr,
+       .ndo_validate_addr      = eth_validate_addr,
+};
+
 /* This is the real probe routine.  Linux has a history of friendly device
    probes on the ISA bus.  A good device probes avoids doing writes, and
    verifies that the correct device exists and functions.  */
@@ -332,12 +343,8 @@ static int __init seeq8005_probe1(struct net_device *dev, int ioaddr)
                 }
        }
 #endif
-       dev->open               = seeq8005_open;
-       dev->stop               = seeq8005_close;
-       dev->hard_start_xmit    = seeq8005_send_packet;
-       dev->tx_timeout         = seeq8005_timeout;
+       dev->netdev_ops = &seeq8005_netdev_ops;
        dev->watchdog_timeo     = HZ/20;
-       dev->set_multicast_list = set_multicast_list;
        dev->flags &= ~IFF_MULTICAST;
 
        return 0;