ni5010: convert to net_device_ops
Alexander Beregalov [Sun, 29 Mar 2009 06:37:27 +0000 (23:37 -0700)]
Signed-off-by: Alexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ni5010.c

index 539e18a..2a8da47 100644 (file)
@@ -189,6 +189,17 @@ static void __init trigger_irq(int ioaddr)
                outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
 }
 
+static const struct net_device_ops ni5010_netdev_ops = {
+       .ndo_open               = ni5010_open,
+       .ndo_stop               = ni5010_close,
+       .ndo_start_xmit         = ni5010_send_packet,
+       .ndo_set_multicast_list = ni5010_set_multicast_list,
+       .ndo_tx_timeout         = ni5010_timeout,
+       .ndo_validate_addr      = eth_validate_addr,
+       .ndo_set_mac_address    = eth_mac_addr,
+       .ndo_change_mtu         = eth_change_mtu,
+};
+
 /*
  *      This is the real probe routine.  Linux has a history of friendly device
  *      probes on the ISA bus.  A good device probes avoids doing writes, and
@@ -328,13 +339,8 @@ static int __init ni5010_probe1(struct net_device *dev, int ioaddr)
                outb(0, IE_RBUF);       /* set buffer byte 0 to 0 again */
        }
         printk("-> bufsize rcv/xmt=%d/%d\n", bufsize_rcv, NI5010_BUFSIZE);
-       memset(netdev_priv(dev), 0, sizeof(struct ni5010_local));
 
-       dev->open               = ni5010_open;
-       dev->stop               = ni5010_close;
-       dev->hard_start_xmit    = ni5010_send_packet;
-       dev->set_multicast_list = ni5010_set_multicast_list;
-       dev->tx_timeout         = ni5010_timeout;
+       dev->netdev_ops         = &ni5010_netdev_ops;
        dev->watchdog_timeo     = HZ/20;
 
        dev->flags &= ~IFF_MULTICAST;   /* Multicast doesn't work */