IB/ipath: Properly terminate PCI ID table
Roland Dreier [Fri, 12 May 2006 21:57:52 +0000 (14:57 -0700)]
The ipath driver's table of PCI IDs needs a { 0, } entry at the end.
This makes all of the device aliases visible to userspace so hotplug
loads the module for all supported devices.  Without the patch,
modinfo ipath_core only shows:

    alias:          pci:v00001FC1d0000000Dsv*sd*bc*sc*i*

instead of the correct:

    alias:          pci:v00001FC1d00000010sv*sd*bc*sc*i*
    alias:          pci:v00001FC1d0000000Dsv*sd*bc*sc*i*

Signed-off-by: Roland Dreier <rolandd@cisco.com>
Signed-off-by: Bryan O'Sullivan <bos@pathscale.com>

drivers/infiniband/hw/ipath/ipath_driver.c

index 398add4..3697eda 100644 (file)
@@ -116,10 +116,9 @@ static int __devinit ipath_init_one(struct pci_dev *,
 #define PCI_DEVICE_ID_INFINIPATH_PE800 0x10
 
 static const struct pci_device_id ipath_pci_tbl[] = {
-       {PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE,
-                   PCI_DEVICE_ID_INFINIPATH_HT)},
-       {PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE,
-                   PCI_DEVICE_ID_INFINIPATH_PE800)},
+       { PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_HT) },
+       { PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_PE800) },
+       { 0, }
 };
 
 MODULE_DEVICE_TABLE(pci, ipath_pci_tbl);