3c503: convert to net_device_ops
Stephen Hemminger [Wed, 26 Nov 2008 02:26:20 +0000 (18:26 -0800)]
Another of the 8390p group.

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/3c503.c

index 95bd95f..c092c39 100644 (file)
@@ -168,6 +168,21 @@ out:
 }
 #endif
 
+static const struct net_device_ops el2_netdev_ops = {
+       .ndo_open               = el2_open,
+       .ndo_stop               = el2_close,
+
+       .ndo_start_xmit         = eip_start_xmit,
+       .ndo_tx_timeout         = eip_tx_timeout,
+       .ndo_get_stats          = eip_get_stats,
+       .ndo_set_multicast_list = eip_set_multicast_list,
+       .ndo_validate_addr      = eth_validate_addr,
+       .ndo_change_mtu         = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+       .ndo_poll_controller    = eip_poll,
+#endif
+};
+
 /* Probe for the Etherlink II card at I/O port base IOADDR,
    returning non-zero on success.  If found, set the station
    address and memory parameters in DEVICE. */
@@ -335,8 +350,7 @@ el2_probe1(struct net_device *dev, int ioaddr)
 
     ei_status.saved_irq = dev->irq;
 
-    dev->open = &el2_open;
-    dev->stop = &el2_close;
+    dev->netdev_ops = &el2_netdev_ops;
     dev->ethtool_ops = &netdev_ethtool_ops;
 #ifdef CONFIG_NET_POLL_CONTROLLER
     dev->poll_controller = eip_poll;