[netdrvr] smc911x: fix for driver resume (and compilation warning)
Dasgupta, Romit [Thu, 6 Nov 2008 10:16:18 +0000 (15:16 +0530)]
I am trying out suspend, resume on an OMAP3 based board. What I see
during resume is that the SMC911x driver resume routing gets stuck
after trying to transmit the packet out of the controller. Some debug
messages below:

--> smc911x_drv_resume
eth0: --> smc911x_reset
eth0: smc911x_reset timeout waiting for PM restore
eth0: --> smc911x_enable
eth0: --> smc911x_phy_configure()
eth0: --> smc911x_phy_reset()
eth0: phy caps=0x782d
eth0: phy advertised caps=0x0de1
eth0: --> smc911x_phy_check_media
smc911x_phy_read: phyaddr=0x1, phyreg=0x01, phydata=0x7809
smc911x_phy_read: phyaddr=0x1, phyreg=0x01, phydata=0x7809
eth0: link down
Restarting tasks ... eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
nfs: server 172.24.190.217 not responding, still trying
nfs: server 172.24.190.217 not responding, still trying

The following change makes it work fine: (The change within
smc911x_drv_probe function was to get rid of a compilation warning).

Signed-off-by: Romit Dasgupta <romit@ti.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

drivers/net/smc911x.c

index 5051554..1f26ab0 100644 (file)
@@ -2050,7 +2050,9 @@ err_out:
  */
 static int smc911x_drv_probe(struct platform_device *pdev)
 {
+#ifdef SMC_DYNAMIC_BUS_CONFIG
        struct smc911x_platdata *pd = pdev->dev.platform_data;
+#endif
        struct net_device *ndev;
        struct resource *res;
        struct smc911x_local *lp;
@@ -2182,9 +2184,9 @@ static int smc911x_drv_resume(struct platform_device *dev)
 
                if (netif_running(ndev)) {
                        smc911x_reset(ndev);
-                       smc911x_enable(ndev);
                        if (lp->phy_type != 0)
                                smc911x_phy_configure(&lp->phy_configure);
+                       smc911x_enable(ndev);
                        netif_device_attach(ndev);
                }
        }