clocksource: sh_cmt 16-bit fixes
Magnus Damm [Wed, 29 Apr 2009 14:50:37 +0000 (14:50 +0000)]
This patch contains various fixes for 16-bit cmt hardware.
With this applied periodic clockevents work fine on sh7203.

Signed-off-by: Magnus Damm <damm@igel.co.jp>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

drivers/clocksource/sh_cmt.c

index bf3e4c1..4ff1508 100644 (file)
@@ -158,16 +158,18 @@ static int sh_cmt_enable(struct sh_cmt_priv *p, unsigned long *rate)
                pr_err("sh_cmt: cannot enable clock \"%s\"\n", cfg->clk);
                return ret;
        }
-       *rate = clk_get_rate(p->clk) / 8;
 
        /* make sure channel is disabled */
        sh_cmt_start_stop_ch(p, 0);
 
        /* configure channel, periodic mode and maximum timeout */
-       if (p->width == 16)
-               sh_cmt_write(p, CMCSR, 0);
-       else
+       if (p->width == 16) {
+               *rate = clk_get_rate(p->clk) / 512;
+               sh_cmt_write(p, CMCSR, 0x43);
+       } else {
+               *rate = clk_get_rate(p->clk) / 8;
                sh_cmt_write(p, CMCSR, 0x01a4);
+       }
 
        sh_cmt_write(p, CMCOR, 0xffffffff);
        sh_cmt_write(p, CMCNT, 0);
@@ -615,7 +617,7 @@ static int sh_cmt_setup(struct sh_cmt_priv *p, struct platform_device *pdev)
        if (resource_size(res) == 6) {
                p->width = 16;
                p->overflow_bit = 0x80;
-               p->clear_bits = ~0xc0;
+               p->clear_bits = ~0x80;
        } else {
                p->width = 32;
                p->overflow_bit = 0x8000;