mfd: asic3: enable SD/SDIO cell
Philipp Zabel [Mon, 15 Jun 2009 10:10:25 +0000 (12:10 +0200)]
This enables the ASIC3's SD/SDIO MFD cell, supported by the tmio_mmc driver.

Signed-off-by: Philipp Zabel <philipp.zabel@gmail.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>

drivers/mfd/asic3.c

index a90658e..63a2a66 100644 (file)
@@ -27,6 +27,7 @@
 #include <linux/mfd/asic3.h>
 #include <linux/mfd/core.h>
 #include <linux/mfd/ds1wm.h>
+#include <linux/mfd/tmio.h>
 
 enum {
        ASIC3_CLOCK_SPI,
@@ -684,11 +685,106 @@ static struct mfd_cell asic3_cell_ds1wm = {
        .resources     = ds1wm_resources,
 };
 
+static struct tmio_mmc_data asic3_mmc_data = {
+       .hclk = 24576000,
+};
+
+static struct resource asic3_mmc_resources[] = {
+       {
+               .start = ASIC3_SD_CTRL_BASE,
+               .end   = ASIC3_SD_CTRL_BASE + 0x3ff,
+               .flags = IORESOURCE_MEM,
+       },
+       {
+               .start = ASIC3_SD_CONFIG_BASE,
+               .end   = ASIC3_SD_CONFIG_BASE + 0x1ff,
+               .flags = IORESOURCE_MEM,
+       },
+       {
+               .start = 0,
+               .end   = 0,
+               .flags = IORESOURCE_IRQ,
+       },
+};
+
+static int asic3_mmc_enable(struct platform_device *pdev)
+{
+       struct asic3 *asic = dev_get_drvdata(pdev->dev.parent);
+
+       /* Not sure if it must be done bit by bit, but leaving as-is */
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_LEVCD, 1);
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_LEVWP, 1);
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_SUSPEND, 0);
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_PCLR, 0);
+
+       asic3_clk_enable(asic, &asic->clocks[ASIC3_CLOCK_EX0]);
+       /* CLK32 used for card detection and for interruption detection
+        * when HCLK is stopped.
+        */
+       asic3_clk_enable(asic, &asic->clocks[ASIC3_CLOCK_EX1]);
+       msleep(1);
+
+       /* HCLK 24.576 MHz, BCLK 12.288 MHz: */
+       asic3_write_register(asic, ASIC3_OFFSET(CLOCK, SEL),
+               CLOCK_SEL_CX | CLOCK_SEL_SD_HCLK_SEL);
+
+       asic3_clk_enable(asic, &asic->clocks[ASIC3_CLOCK_SD_HOST]);
+       asic3_clk_enable(asic, &asic->clocks[ASIC3_CLOCK_SD_BUS]);
+       msleep(1);
+
+       asic3_set_register(asic, ASIC3_OFFSET(EXTCF, SELECT),
+                          ASIC3_EXTCF_SD_MEM_ENABLE, 1);
+
+       /* Enable SD card slot 3.3V power supply */
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_SDPWR, 1);
+
+       return 0;
+}
+
+static int asic3_mmc_disable(struct platform_device *pdev)
+{
+       struct asic3 *asic = dev_get_drvdata(pdev->dev.parent);
+
+       /* Put in suspend mode */
+       asic3_set_register(asic, ASIC3_OFFSET(SDHWCTRL, SDCONF),
+                          ASIC3_SDHWCTRL_SUSPEND, 1);
+
+       /* Disable clocks */
+       asic3_clk_disable(asic, &asic->clocks[ASIC3_CLOCK_SD_HOST]);
+       asic3_clk_disable(asic, &asic->clocks[ASIC3_CLOCK_SD_BUS]);
+       asic3_clk_disable(asic, &asic->clocks[ASIC3_CLOCK_EX0]);
+       asic3_clk_disable(asic, &asic->clocks[ASIC3_CLOCK_EX1]);
+       return 0;
+}
+
+static struct mfd_cell asic3_cell_mmc = {
+       .name          = "tmio-mmc",
+       .enable        = asic3_mmc_enable,
+       .disable       = asic3_mmc_disable,
+       .driver_data   = &asic3_mmc_data,
+       .num_resources = ARRAY_SIZE(asic3_mmc_resources),
+       .resources     = asic3_mmc_resources,
+};
+
 static int __init asic3_mfd_probe(struct platform_device *pdev,
                                  struct resource *mem)
 {
        struct asic3 *asic = platform_get_drvdata(pdev);
-       int ret;
+       struct resource *mem_sdio;
+       int irq, ret;
+
+       mem_sdio = platform_get_resource(pdev, IORESOURCE_MEM, 1);
+       if (!mem_sdio)
+               dev_dbg(asic->dev, "no SDIO MEM resource\n");
+
+       irq = platform_get_irq(pdev, 1);
+       if (irq < 0)
+               dev_dbg(asic->dev, "no SDIO IRQ resource\n");
 
        /* DS1WM */
        asic3_set_register(asic, ASIC3_OFFSET(EXTCF, SELECT),
@@ -700,9 +796,25 @@ static int __init asic3_mfd_probe(struct platform_device *pdev,
        asic3_cell_ds1wm.platform_data = &asic3_cell_ds1wm;
        asic3_cell_ds1wm.data_size = sizeof(asic3_cell_ds1wm);
 
+       /* MMC */
+       asic3_mmc_resources[0].start >>= asic->bus_shift;
+       asic3_mmc_resources[0].end   >>= asic->bus_shift;
+       asic3_mmc_resources[1].start >>= asic->bus_shift;
+       asic3_mmc_resources[1].end   >>= asic->bus_shift;
+
+       asic3_cell_mmc.platform_data = &asic3_cell_mmc;
+       asic3_cell_mmc.data_size = sizeof(asic3_cell_mmc);
+
        ret = mfd_add_devices(&pdev->dev, pdev->id,
                        &asic3_cell_ds1wm, 1, mem, asic->irq_base);
+       if (ret < 0)
+               goto out;
+
+       if (mem_sdio && (irq >= 0))
+               ret = mfd_add_devices(&pdev->dev, pdev->id,
+                       &asic3_cell_mmc, 1, mem_sdio, irq);
 
+ out:
        return ret;
 }