[ARM] mv78xx0: force link speed/duplex on eth2/eth3
Lennert Buytenhek [Wed, 8 Oct 2008 21:41:19 +0000 (23:41 +0200)]
On the mv78xx0 development board, eth2 and eth3 do not have
corresponding PHYs, but are internally connected, as a way of
facilitating communication between the two CPU cores.  Since there are
no PHYs, we need to tell the network driver explicitly to force the
link on eth2 and eth3 up, to 1000 Mb/s full duplex.

Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
Signed-off-by: Nicolas Pitre <nico@marvell.com>

arch/arm/mach-mv78xx0/db78x00-bp-setup.c

index 49f434c..2e285bb 100644 (file)
@@ -13,6 +13,7 @@
 #include <linux/platform_device.h>
 #include <linux/ata_platform.h>
 #include <linux/mv643xx_eth.h>
+#include <linux/ethtool.h>
 #include <mach/mv78xx0.h>
 #include <asm/mach-types.h>
 #include <asm/mach/arch.h>
@@ -28,10 +29,14 @@ static struct mv643xx_eth_platform_data db78x00_ge01_data = {
 
 static struct mv643xx_eth_platform_data db78x00_ge10_data = {
        .phy_addr       = MV643XX_ETH_PHY_NONE,
+       .speed          = SPEED_1000,
+       .duplex         = DUPLEX_FULL,
 };
 
 static struct mv643xx_eth_platform_data db78x00_ge11_data = {
        .phy_addr       = MV643XX_ETH_PHY_NONE,
+       .speed          = SPEED_1000,
+       .duplex         = DUPLEX_FULL,
 };
 
 static struct mv_sata_platform_data db78x00_sata_data = {